1.3.3

1 files changed, 10 insertions, 2 deletions

diff --git a/examples/Auto_Range/Auto_Range.ino b/examples/Auto_Range/Auto_Range.ino
index 5cef117..31d494e 100644
--- a/examples/Auto_Range/Auto_Range.ino
+++ b/examples/Auto_Range/Auto_Range.ino
@@ -112,6 +112,13 @@ void setup() {
    */

   //adc.setAlertPinToConversionReady(); //uncomment if you want to change the default

 

+  /* Enable or disable permanent automatic range selection mode. If enabled, the range will

+   * change if the measured values are outside of 30-80% of the maximum value of the current 

+   * range.  

+   * !!! Use EITHER this function once OR setAutoRange() whenever needed (see below) !!!

+   */

+  adc.setPermanentAutoRangeMode(true);

+

   Serial.println("ADS1115 Example Sketch - Continuous Mode with Auto Range");

   Serial.println();

 }

@@ -150,10 +157,11 @@ float readChannel(ADS1115_MUX channel) {
    * would need for three conversions. 

    * If the ADS115 is in single shot mode, setAutoRange() will switch into continuous

    * mode to measure a value and switch back again.

+   * !!! Use EITHER this function whenever needed OR setPermanentAutoRangeMode(true) once !!!

    */

-  adc.setAutoRange();

-  printVoltageRange(); // this is just to show that the range is changing with changing voltages 

+  //adc.setAutoRange();

   adc.getResult_mV();

+  printVoltageRange(); // this is just to show that the range is changing with changing voltages 

   voltage = adc.getResult_V(); // alternative: getResult_mV for Millivolt

   return voltage;

 }